Pecoware Thermostat TC170 User Manual download pdf (Page 3)

WIRING DIAGRAM

OUTPUT CONFIGURATION

A table is provided on the inside of the base to docu-

ment the function of various outputs. The function of

congurable outputs should be lled in when the unit is

installed.

JP4 JUMPER SELECTION

This jumper is temporarily installed at initial power

up to recongure outputs 3 through 6. See Output

Conguration.

JP3 JUMPER SELECTION

This jumper is shipped normally open. Placement

of a jumper onto both pins allows for Occupancy

Detection/ Door switch and Door Switch Only

Operation.

JP1 JUMPER SELECTION

Removing this jumper allows the sensor to be lo-

cated in a remote location. Accessory remote probe

sensors are available in standard 60” lengths but

can be extended to meet application requirements.

SWITCH

24 V

110-

277V

HIGH -VOL TAGE - REMOVE POWER BEFORE SER VICING

CAUTION:

JP 1

JP 3

JP 4

JP1 JUMPER

JP3 JUMPER

JP4 JUMPER

CIRCUIT BOARD

In Cover

SWITCH POSITION

This switc h i s p laced in the 24V positio n a t the

factor y. Thi s t hermostat will not functio n

properly if located in 110-277V positio n

INPUT

VOLTAGE

OUTPUT RA TINGS

24 VAC

PILOT

DUTY

24 VA

VOLTAGE

24 VAC

1 2 3 4

Comments to this Manuals

No comments

Pecoware Thermostat TC170 User Manual Page 3

Comments to this Manuals